-
ENGL FIREBALL 100W HEAD
1.490,00 €- 100 W, 2 Channels
Controls:
- Clean gain
- Lead gain
- Bass
- Middle
- Treble
- Lead volume
- Master A
- Master B
- Presence
- Mid boost
- Channel switch
- Adjustable noise gate
- Switchable effects
- Tube Monitor system
- 4 x ECC83
- 4 x 6L6GC
- Dimensions: 71 x 27 x 27 cm
- Weight: 22 kg
-
ENGL POWERBALL II E645/2 100W HEAD
1.600,00 €- 4 Channels with 4 gain controls: Clean Gain 1 – Crunch Gain 2 – Lead Gain 3 – Lead Gain 4
- Two tonally different lead sounds
- 2x Master volume
- Electronic Power Tube Monitoring
- 6L6GC Tubes
- Electronic power amp monitoring
- Adjustable effects loop (parallel – serial), also controllable by foot
- 2 Bottom Sound switches for Lead Channel 3 and Lead Channel 4
- Depth Punch
- Mid Boost switching
- Adjustable Noise Gate in lead mode now also controllable via foot
- Dimensions (L x H x D) 71 x 27 x 27 cm
- Weight: 21 kg
-
ENGL SAVAGE 60W HEAD
2.199,00 €- 4 Channels: Clean, Crunch I, Crunch II, Lead
- Power: 60 W
- Full tube design – no semiconductors in the signal path
- Preamp tubes: 6 X Engl ECC83 / 12AX7
- Power tubes: 2x Engl EL34
- 2 Tube-driven FX loops with separate balance controls
- Noise Gate with adjustable threshold (footswitchable)
- Engl Power Tube Monitor
- MIDI in / MIDI thru
- Engl MIDI foot controller phantom power switch
- MIDI Channel Assignment and Controller Enable Switch
- Write / Copy (for MIDI programming)
- All switching functions MIDI programmable (excluding Power and Stand By)
- S.A.C.: Serial Amp Control port
- Sound Switching options: Input Lo / Hi, Bright, Preshape, Contour (Clean, Crunch I), Mid Le./Bo., Depth Boost, Gain Lo / Hi, Contour (Crunch II, Lead), Rough / Smooth
- Controls: Gain (separate for each channel), Bass, Mid Lean, Mid Bold, Treble (Clean, Crunch I), Bass, Middle, Treble, Tone Balance (Crunch II, Lead), Volume (separate for each channel), Presence A, Presence B, Master A, Master B
- Controls (rear side) for Noise Gate Threshold Level, FX Loop I Balance, FX Loop II Balance
- Outputs: 1 x 4 Ohm, 2 x 8 Ohm, 2 x 16 Ohm, 1 x 16 Ohm
- Line out
- Dimensions (W x H x D): 71 x 27 x 29 cm
- Weight: 21 kg
-
GALLIEN KRUEGER LEGACY 800 BASS HEAD
899,00 €- Potenza: 800W
- EQ attivo a 4 bande
- Filtri voicing: Bump, Contour e Presence
- Uscita XLR bilanciata con Pre e Post EQ
- Jack 1/4″ sbilanciato send e return
- Ingresso aux
- Uscita cuffie
- Uscite speaker twist lock
-
HARTKE HA2500 BASS HEAD
345,00 €- Power: 250W into 4Ω, 180W into 8Ω
- Tube emulation & solid-state precursors
- Bass & treble contour controller
- 10-Band graphic EQ
- Adjustable compressor
- Passive / active input jacks
- DI-out with pre / post switch
- Dimensions: 44 x 9 x 33 cm
- Weight: 15.2 kg
-
HARTKE LH500 BASS HEAD
395,00 €- 500 Watt
- Tube preamp with 12AX7 Class-A tube preamp circuit
- 3-Band EQ
- Bright Switch
- Limiter Switch with LED Indicator
- Balanced XLR DI-Out
- Balanced direct output
- Effects loop
- Dimensions: 483 mm x 369 mm x 83 mm
- Weight: 10.5 kg
-
HARTKE LX5500 BASS HEAD
435,00 €- 12AX7 Class A tube preamp
- Power: 500W
- Jack active/passive input
- XLR DI output with ground lift
- FX loop
- Speaker connections: Speaker Twist and jack
- Dimensions (W x D x H): 355 x 270 x 73 mm
- Weight: 3.9 kg
-
MARSHALL JCM900 100W HEAD
1.400,00 €- Dual Reverb
- Power: 100 W
- 4 x 5881 power tubes
- 3 x ECC83 preamp tubes
- Reverb (Accutronics)
- 4-band EQ
- Effects loop
- Direct Recording Output
- High/Low output selector switch
- LED tube defect indicator
-
MARSHALL JVM410H 100W HEAD
1.270,00 €- 4 channels with all-tube technology – no semiconductor in signal path
- Preamp tubes: 5 x ECC 83
- Power amp tubes: 4 x EL34
- Individual 3-band EQ as well as gain and volume for each channel
- 12 basic sounds can be chosen directly via foot switch or MIDI
- EL34 power amplifier with presence and resonance control
- 2 switchable and programmable master volume controls
- Programmable parallel FX loop with hardware bypass
- Digital reverb with individual controls for each channel
- Series insert loop with hardware bypass circuit
- Emulated DI out
- MIDI IN and MIDI THRU
- Dimensions:: 740 x 310 x 215 mm
- Weight: 22 kg
- Foot switch included
-
Marshall Studio JTM ST20H Head
880,00 €- basato sul classico look vintage
- Suono dal vintage al crunch
- Potenza: 20 W con riduzione della potenza a 5 W
- Valvole di preamplificazione: 3 x ECC 83
- Valvole di potenza: 2 x 5881
-
Marshall Studio Vintage SV20H
810,00 €- Preamplificatore basato sul classico SLP del 1959
- 1 canale con 4 ingressi separati
- Potenza: 20 W con riduzione di potenza a 5 W
- Valvole: 2 x ECC83, 1 x ECC83 (phase splitter), 2 x EL34
- Uscita DI
- Loop FX seriale
- Dimensioni: 500 x 240 x 230 mm
- Peso: 9,25 kg.
-
MARSHALL SV20H HEAD
815,00 €L’amplificatore Marshall Studio Vintage SV20H è una testata Made in UK 20 Watt, basata sull’iconica 1959SLP con caratteristiche utili al chitarrista moderno come lo switch per riduzione di potenza a 5 Watt e uscita DI.
Gli Amplificatori Studio Vintage sono basati sull’amplificatore che ha ispirato generazioni di iconici chitarristi: 1959SLP. Forniscono il tono e le armoniche che ci si aspetta dal 1959SLP in un formato facilmente trasportabile. Gli amplificatori Studio Vintage sono perfetto per suonare di tutto, dai Blues saturi ai Lead del Classic Rock. Sono provvisti di 4 Input così da poter miscelare il tuo suono, una sezione EQ con controllo Presence, uscita DI e riduzione di potenza da 20 a 5 Watt.
Specifiche:
Valvole: 2 x ECC83, 1x ECC83 (Phase Splitter), 2x EL34
Canali: 1 canale con 4 input separati
Input: 4 Low Sensitivity e High Sensitivity
Controlli: Volume Preamp, Bass, Middle, High, Presence, Volume Master
Controllo di potenza: 20 Watt e 5 Watt
Speaker Output: 5x 1/4″ (16 Ohm, 8 Ohm, 4 Ohm)
Output: DI